Volos Projects recently showcased an easy-to-reproduce, inexpensive DIY ESP32-S3 Internet radio based on a Waveshare ESP32-S3-LCD-1.54 development board ...

What did Elliot Williams and Al Williams read on Hackaday last week? Tune in and find out. After a bit of news, [Vik Oliver] chimes in with some deep PLA knowledge. Then the topic changed to ...

In this video, I created a blood oximeter by using the MAX30105 particle sensor to figure out the changes in color of passing ...

In this video I'm walking you through the steps I took to make a standalone version of my pellet level monitoring sensor that ...

The Edge AI Elektor Engineering Insights on April 8 will examine how App Lab and Edge Impulse streamline training, deployment ...

Building a DIY Arduino game controller requires specific hardware components. The table below lists all the components required to build the Arduino Uno game controller project. These components are ...

The sensor continuously sends out infrared light and measures how much of that light is reflected. When a reflective object is within its set detection range, it returns a low signal. The Arduino ...

In today's lecture, we will design a project in Proteus, where we will Interface Gas Sensor with Arduino. I will provide the complete code and simulation. Gas sensors are widely used in fire alarms, ...

The world of car diagnostics has changed a lot over the last 50 years. Back in the '70s and earlier, a mechanic's most valuable diagnostic tools were usually their eyes and ears. You could figure out ...

The P0118 code means that the engine control module (ECM) has detected a voltage signal that’s too high from the engine coolant temperature (ECT) sensor (below). In practical terms, the ECM believes ...

Arduino is being acquired by Qualcomm subject to regulatory approval for an undisclosed sum. Qualcomm Arduino introduces a new UNO form factor board, the Arduino UNO Q, which features both a STM32 MCU ...